Home > Gentoo, KDE, Tyler B > Closed source AMD/ATI drivers, wireless networking and Flash in Gentoo

Closed source AMD/ATI drivers, wireless networking and Flash in Gentoo

Graphics Drivers

Continuing where I left off in my previous posts I now had a somewhat working desktop but a few things still had to be done. For one I am running this on my laptop and while the open source radeon drivers are actually pretty decent they’re just not quite good enough when it comes to power management. Thankfully the Linux closed source drivers are up to the job.

After reading through these two sites I was able to install the closed source drivers and get full control over my graphics card. To be perfectly honest I’m not exactly sure what steps got me to this point but I do know it was a mixture of the two sites.

Wireless Networking

After careful consideration I had come to the conclusion thought I had bricked my wireless. Worse yet after following the guide here (even the parts specific to KDE) I just couldn’t seem to get it to work. Thankfully I stumbled upon this guide which instructed me to install networking components for KDE. Apparently once I had installed this package all was good.

Flash

Flash was actually incredibly easy to install. All I had to do was enter the following command in a root terminal and then restart Firefox.

emerge adobe-flash

Java

Another big install was the official Oracle Java JRE and JDK. To install just the JRE run the command dev-java/sun-jre-bin. If you want the JDK as well then run the command dev-java/sun-jdk. The only weird part about this was that this package is now considered restricted. To work around it simply download the bin file from Oracle and place it in /usr/portage/distfiles before running the command.

More to Come

There is still plenty more to do, like install LibreOffice and figure out why my computer currently can’t play audio CDs. I am however thankful that at this point I am at least a bit better off than some other fellow Linux Experiment participants.

My Desktop So Far

The high CPU load was because I had just finished compiling a bunch of stuff :P




I am currently running a variety of distributions, primarily Linux Mint 17.
Previously I was running KDE 4.3.3 on top of Fedora 11 (for the first experiment) and KDE 4.6.5 on top of Gentoo (for the second experiment).
Check out my profile for more information.
  1. No comments yet.
  1. No trackbacks yet.