Fix PulseAudio loopback delay
Sort of a follow up (in spirit) to two of Jon’s previous posts regarding pulse audio loopback; I noticed that there was quite a bit of delay (~500ms to 1second) in the default configuration and began searching for a way to fix it. After some research I found an alternative way to achieve the loopback but with must less delay.
1. Install paman
First install the PulseAudio Manager application so that you can correctly identify the input device (i.e. your mic or line-in) and your output device (i.e. the sound card you are using).
sudo apt-get install paman
You can find the input sources under the Sources section and the output devices under the Sinks section of the Devices tab. Make note of the names of the two devices.
2. Unload any previous loopback modules
If you had followed Jon’s previous posts then you will need to unload the modules (and potentially change your PulseAudio configuration so they don’t get loaded again on next restart). This is to stop it from doubling all loopback sound.
3. Create an executable script
Create a script and copy the following command into it:
pacat -r --latency-msec=1 -d [input] | pacat -p --latency-msec=1 -d [output]
where [input] is the name of your input device found in step 1 and [output] is the name of the output device. In my case it would look like:
pacat -r --latency-msec=1 -d alsa_input.pci-0000_05_02.0.analog-stereo | pacat -p --latency-msec=1 -d alsa_output.pci-0000_05_02.0.analog-surround-51
4. Run script
By simply running the script now you should get correct loopback and with much less delay than using the default loopback module. Even better if you set this script to run at startup you won’t have to worry about it ever again.
Previously I was running KDE 4.3.3 on top of Fedora 11 (for the first experiment) and KDE 4.6.5 on top of Gentoo (for the second experiment).
Check out my profile for more information.
Visit my personal website at http://www.tylerburton.ca.