Just a quick note tonight – I finally managed to get a bootable Gentoo system installed!
After my last post, things were looking pretty grim. Instead of continuing to perpetuate the recompile/reboot cycle, I decided to start fresh, in hopes that I had simply missed a step the first time around. With this in mind, I started back at page one of the Gentoo Handbook and worked my way through the entire thing.
When it came time to compile my kernel, I opted for a slightly less error-prone method, and started off by installing Genkernel, a tool that automates some of the kernel creation steps. When running it however, I was sure to pass the –menuconfig parameter, which gave me full control over what modules were included in the final product.
Next, I followed the kernel tutorials in the Gentoo Handbook and on the Gentoo Wiki Asus P5Q-E page. This ensured that I included every component that was necessary for my system.
Once I rebooted the machine, a login prompt came up the first time. Great success indeed!
One little gotcha that’s important to note at this step. On my first login, I didn’t have any network access. Two things that might help:
- Open up /etc/conf.d/net in nano and add a line like config_eth0=”dhcp” for each network interface in your machine, where eth0 is the name of the interface. This tells the machine to use DHCP when initializing the device. On most home networks, this will get you an IP address.
- Make sure that any required modules are loaded. I have two network interfaces. One uses the sky2 module, and the other uses skge. You can check to ensure that these are loaded with the command lsmod | grep sky2 where sky2 is the name of the module that you’re looking for. If it isn’t loaded, run modprobe sky2 to get it up and running. Note that you may need to recompile your kernel with support for the module in question if you missed it first time ’round.
Tomorrow, I’ll compile an X11 server, and hopefully get started on the GNOME desktop environment. Christ there’s still a lot to do…
On my home media server, I am running Ubuntu 12.04
Check out my profile for more information.